Troubleshooting after installation of vulcanized rubber machine

Troubleshooting after installation of vulcanized rubber machine
Vulcanized rubber machine is a type of equipment used for processing rubber products, which often experiences some malfunctions after installation. This article will investigate and solve the faults of the vulcanized rubber machine after installation, in order to improve the stability and efficiency of the equipment.
1、 Check if the machine starts normally. Firstly, check if the power cord is securely connected and confirm that the power supply is functioning properly. Secondly, check if the manual and automatic start buttons are faulty. If any problems occur, replace or repair them in a timely manner. Furthermore, to check whether the main motor is operating properly, one can judge by listening to the sound or observing whether the motor rotates smoothly. If the motor is abnormal, it may be a malfunction of the motor itself, and professional maintenance personnel need to be contacted for maintenance.
2、 Check if the machine is running properly. Firstly, check if there are any abnormalities in the transmission system. For example, check if the chain or belt is loose or worn, and if there are problems, adjust or replace them in a timely manner. Secondly, check whether various touch switches, sensors, and limit switches are working properly to ensure safe and reliable machine operation. If there is a malfunction or damage, these switches need to be repaired or replaced in a timely manner.
3、 Check the heating system of the vulcanized rubber machine. Firstly, check if the heating device can heat up normally. The temperature of the heating device can be measured using an infrared thermometer to ensure that the temperature reaches the set value. If the temperature is insufficient, it may be due to damage to the heating element, which needs to be replaced in a timely manner. Secondly, check if the heating medium flows smoothly to ensure that the medium supply is normal. If the medium supply is insufficient or interrupted, it is necessary to check whether the pipeline is blocked or the pump is working abnormally, and clean or repair it.

4、 Check the cooling system of the machine. Firstly, check if the cooling water supply is normal. If the cooling water flow is insufficient or interrupted, it may be due to pipeline blockage or pump failure, which requires cleaning or maintenance. Secondly, check if the cooling device is working properly to ensure that the temperature reaches the set value. If the temperature is too high, it may be due to insufficient cooling water flow or radiator blockage, which requires corresponding troubleshooting and maintenance.
5、 Check the control system of the vulcanization rubber machine. Firstly, check if the control panel is functioning properly. If the control panel cannot operate or displays abnormally, it may be due to a controller malfunction and needs to be replaced in a timely manner. Secondly, check if the signal transmission of the control system is normal. For example, check if various sensors and actuators are connected correctly and working properly. If the signal transmission is abnormal, it may be due to sensor damage or wiring failure, which needs to be repaired in a timely manner.